Custom Fitting
Is Available With All AccuSwing Irons!
Accuswing EZ2Hit™ Irons
The make-up of the modern set of golf clubs
continues to evolve. The latest trend towards substituting fairway
woods or hybrids for long irons continues to grow at all levels of
play. Both higher lofted fairway woods and hybrids are excellent
replacements for the long irons (1 thru 4 irons). Even tour pros
are carrying fewer long irons these days. Most players find hybrids
and higher lofted fairway woods much easier to use and much more
fun to hit. First the Accuswing Irons.
Accuswing
EZ2Hit™ Irons The
Accuswing EZ2Hit irons are made of 431 stainless steel
and come with steel or graphite shafts in right or left hand
models.
This modern design system has three separate head designs,
created to combat the common problems most players have playing
irons.
1 - Long irons-

The 3 and 4 irons are cavity back designs with perimeter weighting
to add forgiveness on off center hits. In each cavity there is a
thin muscle back member to add mass behind the strike of the ball;
and to allow players to more readily “work” the ball from left to
right or right to left as they desire. The soles are heavily
weighted to place the center of mass low in the head. This allows
players to get a higher launch angle on their shots than is
customary on what are normally difficult irons to use.
2- Mid irons-

The 5, 6 and 7 irons are considered to be mid irons. Here the same
basic cavity back design of the long irons is used, but the muscle
back member in the cavity is thicker. This adds more effective mass
where the ball is struck which in turn yields greater
distance. And it allows players to work the ball as they may
need.
3- Short irons-

The 8, 9 and PW have the traditional muscle back design as was
found in forged clubs years ago. This provides a classical high
spin shot that tends to hold the green well. The modern cavity back
designs make it difficult to curve the ball in flight, to get
around obstacles, to land near well hidden pins. This design
overcomes the problem.

The iron faces are only 73 mm’s long measured from heel to toe.
This lowers the resistance to swinging each club (the moment of
inertia) by bringing the center of mass of the head closer to
shaft That in turn increases swing speed. An added benefit is
that smaller face lengths chop through the rough more readily
without tangling, and allows for better recoveries.
Each leading edge of the sole has a pro grind radius (e.g., a
rounded front edge) to prevent chunking and stubbing from the
fairway.
The soles are also radiused (or rounded) when viewed face on.
This avoids the catching of the toe or heel on side hill lies that
will turn the club off the target line.
These irons are available in the following sets, recognizing
that some players will want to substitute fairway woods or hybrids
for some of the longer irons:-
SPECIFICATIONS
The EZ2HIT iron lengths we use as our standard are as follows:-

Women’s lengths are 1 inch shorter.
We custom fit to your needs so these lengths can be adjusted up or
down in ½” increments.
All irons are made with True Temper TT Lite steel shafts or our
proprietary Prestige 75 graphite shafts. For those seeking greater
control, the True Temper Dynamic Gold steel shafts (R-300, S-300
& X-100) are offered as an option.
Shafts The
shafts available are: (During the order Process you will be
asked to choose
TT Lite (steel) - stiff, firm, regular, senior
& ladies
Dynamic Gold (steel) - R- 300, S- 300, X- 100
Prestige Graphite - stiff, firm, regular, senior
& ladies
You can fit yourself if you know your spec's or we'll be happyl
recommend a shaft based on your filling out our fitting
questionaire.
In general graphite shafts will produce a little more distance,
since they are lighter than steel and the clubs can be made
effectively longer. The slight downside to graphite shafts is that
with very strong swings they will twist more than steel on off
center hits, producing a slightly wider dispersion pattern.
In the past most players who could hit their 7 irons more than
150 yards tended to use steel shafts. The trade off - greater
distance versus greater accuracy - varies from individual to
individual. Many seniors and ladies prefer graphite shafts, feeling
that distance is their greatest problem. Some low
handicappers also use graphite shafts since they tend to make
square contact on the club face and get all the accuracy they need
anyway.
We spine align all shafts for shot consistency during play.
All Clubs Are Custom Fitted and MOI Matched. We make all
the irons of a given set as moment of inertia (MOI) matched clubs.
In straight line motion the unit of resistance is simply mass. In
curvilinear motion, where we rotate the club around an axis, the
unit of resistance is the moment of inertia (MOI, or I) of the
entire club. This matching means the player can accelerate each
club in the set with the same input energy. To put it another way,
each club will swing the same. This leads to better, consistent
play.
Grips
During the club fitting process grip selection will be covered. If
you choose grips that are more expensive than standard there may be
a slight upcharge to cover the additional costs. Standard grips is
Golf Pride Tour Wraps or Lamkin oversized.
Moment Of Inertia (MOI) Our narrower irons
have a total lower moment of inertia than typically found, which
leads to higher swing speeds.
Higher club MOI’s about the shaft often leave the face open at
impact and contributes to pushes and slices. A player fighting a
slice is clearly better off with a lower MOI which will tend to
close the face more at impact.
In general, the longer the club is, or the heavier the head is,
the higher the MOI will be. Conversely, the shorter the club
and/or, the lighter the head, the lower the MOI will be.
The actual values of MOI we use vary for each skill and strength
level, generally higher for the long hitters and lower for the
shorter hitters. That is, higher MOI’s will feel “heavier” while
lower MOI’s will feel “lighter” and easier to swing. Our MOI values
have been established by us over the years, and are time proven to
cover the full range of players.
For those who care to pursue moment of inertia in greater
detail look here MOI.
Have any
questions. Let us give you some expert
advice. Just call Joe Davidson of Simple Golf at 203-798-8489 and
he'll be happy to answer all your questions. If Joe can't answer
any of your question he'll put you in touch with Harry our master
club fitter.
Try It Out First - Order
A 8 Iron Demo Club
(If you'd like another iron other than the 8 iron as a demo
call us an we'll try to work it out for you.)
Only $45 Order Now (Was $60)

Money Back
Guarantee: If you for any reason you don't like
your Accuswing demo iron just return the club within 30 days and
we'll give you a money back refund minus s&h.
Custom Fitting
Available Your AccuSwing irons can
be custom fitted to you by our master clubfitter (Harry Lundberg).
The fitting will be done by e-mail and by phone. After you make
your purchase we will put you in touch directly with Harry.
When you are custom fit by Harry you are in good company because
Harry has worked with PGA tour players, LPA tour players and Senior
PGA tour players. If your travel plans include the Connecticut
shoreline we may even be able to schedule a hands-on personal
fitting. For additional information see our Custom Fitting
Page.
These irons are available in the following sets, recognizing
that some players will want to substitute fairway woods or hybrids
for some of the longer irons:- If you're not sure about a set, order a demo
7 iron (see above). You'll be amazed by these great
clubs
Our standard grip is the Golf Pride Tour
Wrap. Other grip options are available upon
request. If you have a special grip requirement please contact us
prior to ordering or put your grip request in the comment field
during checkout.
Shipping Information We generally ship using
the United States Postal Service. For standard domestic shipping,
the shipping the cost should appear with your
product.
International
Shipping
There will be an upcharge to cover the cost of International
shipping. If you contact us
at prior to placing
your order we can give you a quote of the exact shipping
charges.
Delivery Times
Expect delivery of clubs in a week to 10 days for US
orders. On International orders it will be
closer to 2 to 3 weeks depending on where we are
shipping. (Canadian Orders 1 to 2 weeks) If
you need faster shipping or have special shipping
requirements please contact us prior to ordering for quote. The 2nd
Day Air shipping option is not available for
clubs.
# 6 thru PW Accuswing EZ2Hit Iron
Set
Starting At Only $225 (Was $300)
with TT Lite Shafts Order Now

# 5 thru PW Accuswing EZ2Hit Iron
Set Starting At Only $270
Order Now (Was $360) 
# 4 thru PW Accuswing EZ2Hit Iron
Set
Starting At Only $315 Order
Now (Was $420) 
# 3 thru PW Accuswing EZ2Hit Iron
Set
Starting At Only $360 Order Now (Was
$450)


|